Updating astro spectra flashcode sex usa east asia dating
It's nice to see a good threw the roof antenna install. My only suggestion is to simply move your front roof rack cross-member back 1-2 notches. everybody the Comet dual bander is what i had on hand (never liked the darn thing) as Momma only drives about town and my normal 5/8 wave whip is of no benefit for her use and i was hoping to someday find a dual band radio i dont hate.......There is enough metal in that thing to screw with your swr and or the antenna pattern. It's more of an issue with 5/8th and 1/4wave antennas than 1/2wave units. ill probably end up putting one of my lowband maxtrac rigs in there and say "yup she is a dual band jeep 6 and 2 " Looks nice.Don’t rely on aftermarket cables purchased from e Bay and/or CPS software pirated on some overseas website.Either of these has the potential to damage your radio.but it just seems to be a dangerous place to mount long range communications which could be needed in an emergency.i flooded one of my vehicles interiors once water seeped in through the door jams passenger side was dry drivers side was almost to the top of the trans hump and halfway up the door i was leaning because of a hole some large wheeled vehicle made in a large puddle. luckily i wasn't a ham and the time and the only thing i was out was a cheap cb radio and speaker lol.There is a large online community dedicated to professional radios.Specifically, Batboard, Communications Support, and Radio Reference are great places to visit.
Up-to-date weather information is critical to managing an active incident.
Invest in the right equipment to protect your radio(s) if you want to do-it-yourself.
The accessory port, where your portable radio attaches to a speaker-mic or other accessory, is also used for programming your radio.
really wanted to get a radio in the "Momma Jeep" as my wife is a very new ham i wanted to adhere to the "kiss" theme i couldn't figure out where to mount a Astro W9 head or a Midland STII head so just to keep things simple a Moto CM200 ! ) You will see the best performance from a 1/2wave or 5/8th wave antenna.
i programmed it for 52,the club machine,and couple other locals and set the power to around 20 watts new NMO mount right in front of the dome light and ran the coax over to the front right pillar on above the headliner and down inside the post trim and under the carpet to the console power comes from the lug on the fron power box, i grabbed a ground up there as well its a old yaesu harness so it has those silly fuse shells (when they go to crap ill put those rubber ATC holders up there i will be putting a 1/4 wave whip on it as i cant see the need for that Diamond dual band antenna (i never liked it any way) I haven't done a install for a while so i thought i would share cm200vhf1cm200vhf2nmo&Good stuff I have an XJ myself. However with such a good install even a short 1/4wave antenna is still going to work great.
Then, make the next channel the same main channel but without the restriction.